12mm Metal Button / Switch Short / Self-Locking / Waterproof / Light Ring / Stainless Copper Nickel Plated Button

12mm Metal Button / Switch Short / Self-Locking / Waterproof / Light Ring / Stainless Copper Nickel Plated Button

  • Mounting or drill hole diameter: 12mm
  • Contact Point Type: Momentary or Self Latching
  • Housing Material: Nickel Plated Brass, Stainless Steel or Aluminium Oxide
  • Protection Degree: IP65
  • Product description: 12mm Metal push button switch momentary self locking latching brass stainless steel waterproof Car Auto Engine PC Power Start

Description

DESC metal push button switches are rugged and look real good while installing it! Simply drill a 16mm hole into any material, there’s even a rubber gasket to keep water out of the enclosure. On the front of the button is a flat metal actuator, surrounded by a blue plastic LED ring. On the back there are 3 contacts for the button (common, normally-open and normally-closed) and 2 for the blue LED ring (+ and -). Connect 3 to 6V to the LED to have it light up nicely, there’s a built in resistor! If you want to use this with a higher voltage, say 12V or 24V, simply add a 470 ohm resistor in series with the LED connection to keep the LED current at around 20mA. Also you can order 12V 24V 220V 380V push button directly.

This button has two options. One is momentary push button, when you press it the ‘normally-open’ contact shorts to the common contact. When you release it, the contacts open up again. The other is self locking latching type, when you press it the ‘normally-open’ contact shorts to the common contact. When you release it, the contacts stays the same state. Until you press it again, the contacts will be back to original state.

Technical Specification

Mounting or drill hole diameter: 12mm

Protection Degree: IP65

Switch rating: 3A / 250VDC

Contact resistance: < 50 mOhm

Insulation resistance: > 1000 Mohm

Temperature: -20 C to +55 C

Mechanical life: > 500,000

Electrical life: > 50,000

Panel thickness: 1-13mm

Operating pressure: 1.5 – 2.5 N

Operating stroke: 2mm

Seven steps for selecting Metal Push Button

a. Metal Push Button Switch Drill Hole Diameter (Aperture): 12mm.16mm.19mm.22mm.25mm.30mm

b. Button Head Type:

B-Ball, H-High, F-Flat, E-Ring, D-Single Flashing point.

c. Contact Point Type:

Z-Momentary, No Z Symbol-Self Locking, Latching.

d. Connecting Leg Type:

J-Pins, No J Symbol-Screw

e. Housing Material:

N-Nickel Plated Brass, S-Stainless Steel, A-Aluminium Oxide

f. Colour of Lamp Bead:

Red, Yellow, Blue, Green, White

(22mm 25mm 30mm) push button can make double colour.

g. Switch combination:

10-One Normal Open Point

11-One Normal Open Point One Normal Close Point

22-Two Normal Open Point Two Normal Close Point

h. Voltage:

AC-3V 6V 12V 24V 220V

DC-3V 6V 12V 24V 220V