Description

1. Product introduction:

 

The water flow sensor is mainly composed of a plastic valve body, a water flow rotor assembly and a Hall sensor.

 

It is installed at the water inlet end of the water heater to detect the water flow rate. When the water passes through the water flow rotor assembly,

 

The magnetic rotor rotates and the speed changes with the flow rate, and the Hall sensor outputs corresponding pulses

 

The signal is fed back to the controller, and the controller judges the size of the water flow and regulates it.

 

 

 

 

 

Precautions for use:

 

Severe impact and chemical erosion are strictly prohibited.

Throwing or collision is strictly prohibited.

The temperature of the medium should not exceed 120 degrees

3. Lead wire method:

 

 

 

 

1 Red IN to positive

 

2 Yellow OUT signal output line

 

3 Black GND connect to negative pole

 

 

 

 

 

Frequency: F=7.5*Q(L/Min) Error: ±2%

 

Taking the flow rate of 1L/min as the column, 7.5 * 1 * 60 is equal to the number of pulses output through 1 liter of water. Voltage: 3.5-24VDC, the current cannot exceed 10mA, after one liter of water, 450 pulses will be output

 

That is, frequency calculation = constant 7.5 * unit flow rate (L/min) * time (seconds)

 

Flow range: 1-30L/min

 

Four, technical parameters

 

 

 

Scope of application:

 

Suitable for water heaters, credit card machines, automatic water vending machines, and other flow metering equipment!

 

 

 

 

 

 

 

base

 

this

 

Participate

 

number

 

1. Rated working voltage

 

DC4.5 5V-24V

 

2. Large working current

 

15 mA (DC 5V)

 

3. Operating voltage range

 

DC 518 V

 

4. Load capacity

 

10 mA (DC 5V)

 

5. Operating temperature range

 

80

 

6. Operating humidity range

 

35%90%RH (no frosting state)

 

7. Allowable withstand voltage

 

Water pressure below 1.75Mpa

 

8. Storage temperature

 

-25+ 80

 

9. Keep humidity

 

25%95%RH